sedaerdogan
New Member
Re: opinions on using ideCAD Architecture 7 questions Hello; In line with the value you enter into the scale value, your measurements will increase by so many times and the measurement line will have that value. That is, if you add 00000 to the part that says scale value, the value written on the dimension line will increase by that many times. At this stage, if no rounding is selected, the dimensioning will be done at its full value. As the range grows, the dimension is rounded up to the selected range. The number of digits represents the number of digits written after the comma. If zero is entered, the digit after the comma is not displayed. The program writes the dimensions by rounding them according to the specified number of digits. When you increase the number of digits, it determines the rounding range of the dimensioning. In other words, in your project, 00000 may be written in the scale value and digits may have been entered in the number of digits. The fact that the number of digits came out does not indicate that your drawing is wrong.