Re: Comments on using ideCAD Architecture 7 questions Command line has been very useful under ideCAD 7. 1-) How do we do when we need to customize the commands? 2-) When we press any key from the toolbar, this command appears on the command line (like AutoCAD), making it easier for us to learn the definitions assigned to the commands. It also increases usability. 3-) We would like to see alias like fillet, rotate, block, etc. that we use frequently under AutoCAD, exactly under the ide. 4-) On the other hand, ideCAD's own definitions will be more convenient to use aliases that do not conflict with AutoCAD, such as column (kl), wall (dv), floor (ds), beam (kr). 5-) It may be more practical to set functions such as object capture and Dynamic input at the point where the status bar is located. 6-) Ability to set the properties of commands such as fillet on the command line As I mentioned above, the closer the program command and drawing logic is to AutoCAD, the shorter the adaptation period of the users to the program. Health to your hands...