Steel column and foundation combinations report

mahir58

mahir58

New Member
Hello there; I'm building a steel ladder. In the steel column and foundation combinations, I see the joint calculations related to the connections in the design report. However, when I get a report, I can't see all the joins on the junction design preliminary information page. Is this because the joins I made are the same? If not what is the reason?
 
Re: MERGE ACCOUNT REPORT!..URGENT Hello; Can you get the steel drawing first and then get the joint summary report again? In this way, the names will be included in the column referred to as the detail name in the report. If all the details of the combination are the same, the name will be the same. The account will also come with a single name. When you do this, there is no problem if all your joints with detail number in the steel drawings are 2 like this. If there are more than 2 base plates, please add your project.
 
Re: MERGE ACCOUNT REPORT!..URGENT Hello; If you choose Design-Steel-Combination in the steel tab of the upper toolbar in the program, the design ratios of all the combinations you see in the image below are one by one. You can see the ratio of each one from the perspective screen right click steel design combination d/k ratios tab. If you first take the drawing as in the attached project and then get the union summary report, it will write the detail name and only the ratio of the most unfavorable combination. If you wish, you can add the ratio of all combinations to the report as a screenshot, or you can enter each combination and save the design report as pdf and add it to the report.
 
You must log in or register to reply here.
Back
Top