RIVER BEAM ERROR

E

elifgorel

New Member
HELLO, I CAN'T DRAW A FLOOR SIDE OF THE STAIRS IN THE PROJECT. AFTER ANALYSIS, THE MOLD PLAN DRAWING IS NOT GIVEN, CAN YOU HELP?
 
"elifgorel":3j7sm7ph" said:
HELLO I CAN'T DRAW A FLOOR SIDE OF THE STAIRS IN THE PROJECT CANNOT DRAW A MOLD PLAN AFTER ANALYSIS, CAN YOU HELP? You can define a beam system equal to the floor thickness to cover the perimeter of the stairwell.
Click to expand...
 
In addition, a formwork plan can be obtained in your project. However, you could not see the mold plan because the drawing and columns were created too far from the origin.
 
the formwork plan can be taken yes, what i mean is that the formwork plan drawings are not visible in the account report, and what you say is true, but I don't want to make too many stud beams on the side of the stairs, wouldn't it be right to define transverse teeth in the direction of the long span?
 
The reason why the mold plans do not appear properly in the report is because of the distant objects that I mentioned in the other message. In the last project you added, if you remove the half or missing teeth on your D6 and D13 floors on the ground floor by interfering with the tooth gaps or the initial tooth width, there is no problem with these floors. In addition, it would be appropriate to arrange your beams, which appear halfway in the plan formed on top of your main carrier beams in your other floors. In the other case, you have designed your D17, D14 and D1 floors as a single console. Surround these floors with beams, or design the rib beams to be continuous with the other floors.
 
-Select all the elements you see on the plan by enclosing them in the window. -Click the Invert Selection command from the Edit menu or the toolbar on the left of the screen. -Click the Zoom Selection command from the Image menu. The program will take you to the coordinate where the other elements are located.
 
I CAN'T MOVE IT TO THE CORDINATE SYSTEM, ALSO THERE ARE TYPICAL RIBBON BEAM DETERMINATION ERRORS, CAN YOU EDIT THEM AND SEND THE PROJECT?
 
Remote objects have been deleted in the attached project. For your typical beam problems in rib and cassette systems, if you examine the explanations and video given in the link below, your problem will be solved.
You do not have permission to view link Log in or register now.
 
You must log in or register to reply here.
Back
Top