German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish akif tekin
New Member
hello, I want to make a curved curtain wall, but I need to incline, not as it appears in the picture, how can I do it?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Curtainwall
- Thread starter akif tekin
- Start date
YasinTezel
Member
Re: CLOTHING FACADE
The angle of the curtain wall is exactly right. It is 90 degrees in vertical position. I think you have changed the angle to approximately 40 degrees using the "Sloping Curtain Wall" command. If you enter a degree greater than 90 degrees, such as 110 -120, you can create a curtain wall with any slope."akif tekin":1pnbuwl4" said:hello, I want to make a curved curtain wall, but it is not as shown in the picture, on the contrary, I need to incline, how can I do it?
akif tekin
New Member
Re: DRESSING FACADE it's a bit late but thank you Mr. Yasin.