German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish civilmehmetkara
New Member
Will ventilation gaps, chimney gaps, Sailor ladder gaps be opened as a floor tear during modeling or drawing?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Upholstery Tear
- Thread starter civilmehmetkara
- Start date
The issue to be considered in the floor gaps is whether the working style of the flooring is deteriorated or not. In short, we can answer your question with "yes". However, sometimes friends try to open large gaps in the flooring with this method, which is not true. (This error is seen especially for the stairs connected to the lower floor and the upper floor).
civilmehmetkara
New Member
Thank you sir, after reading your answer, I had a doubt that it was misspelled out of the blue, so I couldn't understand it?
In flooringc air chimneys etc. If there is a case of opening such gaps, we can and should do this while modeling. Of course, we have to show them in the drawing so that the mold maker can leave it blank. Therefore, there should be no crushing and pouring work after the concrete and at the same time it should be equipped with reinforcement.
civilmehmetkara
New Member
Ok, I understand, thank you very much.