The effect of punching reinforcement and its display on the project sheet

[Samet Karataş]

Guys, I wish everyone success. My question is this. In the raft foundation application, I overcome the error by using punching reinforcement on the columns where it gives a punching error (my preference is a uniform spread because it is easy to apply). Is there any downside to this situation? If not, how can I show this reinforcement on the sheet? Thank you for your help.

 

[Levent Özpak]

Friends, I wish everyone success. My question is: I overcome the error by using staple reinforcement on the columns where the stapling error is given in the raft basic application (my preference is a well-spread spreader because it is easy to apply). If so, how can I show this equipment on the sheet? Thank you for your help.

Hello, as indicated in TBDY 2018 article 7.11.11 and Figure 7.16, a tie can be used as a punching reinforcement for the solution of the punching problem. It belongs to the punching equipment you used in the raft punching control report. According to this information, you can edit the punching reinforcement drawings using the two-dimensional drawing possibilities.

 

[cemcerit]

Hello, do you have a sample punching equipment drawing? I am getting a stapling error on 2 columns in a 16 column structure. I solved it with evenly spread cross-ties, but since I am new to project work, I did not know how to show it in the drawing correctly. I would be very happy if you could give an example. Good work

 

[Levent Özpak]

Hi, I wonder if there is a sample punching reinforcement drawing? I am getting a stapling error on 2 columns in a 16 column structure. I solved it with a properly spread cross tie, but since I am new to project work, I did not know how to show it in the drawing correctly. I would be very happy if you could give an example Good work

Hello, the illustration of the punching reinforcement drawings is given in TBDY 2018 figure 7.16 in general. Good work