Stairs not visible

G

gigiveryon

New Member
Hello friends In the attached file, when I want to get the drawings of the stairs after the staircase analysis, the equipment does not show, I have not encountered such a problem before. Where am I doing wrong? My other question is, what should be done other than defining the points where it connects to the flooring under the stair support conditions as both translation and rotation are prevented? Thanks in advance for your answers
 
Hello. Since you are modeling independent of the structure, do the reinforced concrete analysis by clicking the Stair analysis command under Analysis in the Ribbonda Reinforced Concrete tab. You won't get a useful drawing on a spiral staircase. You have to do manual editing.
 
"YasinTezel":2sqc3l6x" said:
Hello Since you are modeling independent of the structure, click the Stairs analysis command under Analysis in the Ribbon Reinforced Concrete tab. If you draw again, the reinforcements will be seen. You cannot get a useful drawing on spiral staircases. You need to manually edit. [/ quote] Thanks a lot, I realized my mistake, how should I set the support conditions, should I set it to prevent translation where it is connected to the floor and where the wall is prevented from turning?
Click to expand...
 
When I get the stairs drawings, there are errors in the sections of oval stairs as reinforcement and formwork. Can I draw the oval reinforced concrete axis and what can I do to fix it?
 
You must log in or register to reply here.
Back
Top