Spontaneous Changes

[brkayacan]

Hello. In the project I am working on, I cannot adjust the misalignment of the leftmost beams and the foundation beams directly below them. It changes by itself when I adjust the offsets. The offset setting that is "top" becomes "bottom" or vice versa. So what am I missing? The project file is attached.

 

[Levent Özpak]

Hello, Your drawing was created at a coordinate far away from the origin. In addition, there are very, very small differences in the coordinates of the objects that should be in the same direction. This is most likely due to the objects you imported. Reconstruct your drawing with the lower left corner at a coordinate close to the origin. Good work

 

[brkayacan]

Hi, Your drawing was created at a coordinate far away from the origin. Also, there are very small differences in the coordinates of the objects that should be in the same direction. This is most likely due to the objects you imported. The lower left corner of your drawing Recreate it in a coordinate close to the origin. Good work

I have moved the objects as close to the origin as possible, but the problem persists. The zoomed version is also attached to this message.

 

[Levent Özpak]

Hi, Your drawing was created at a coordinate far away from the origin. In addition, there are very, very small differences in the coordinates of the objects that should be in the same direction. This is most likely due to the objects you imported. Reconstruct your drawing with the lower left corner at a coordinate close to the origin. Good work

I've moved the entities as close to the origin as possible, but the problem persists. Its approximation to the origin is also attached to this message.

There is still a difference in the coordinates of the objects that should be in the same direction. For example, while the X coordinate of the S19 column is 1860.7582 cm, the X coordinate of the S37 column is 1860.95603 cm. The angle of the D axis is 270.011 degrees... Re-enter your objects, including the axes.

 

[brkayacan]

Hi, Your drawing was created in a coordinate far away from the origin. Also, in the coordinates of the objects that should be in the same direction There are very, very small differences. This is most likely due to the objects you imported. Rebuild your drawing with the lower left corner close to the origin point. Good work

I got the objects as close to the origin as possible, but the problem persists. To the origin The zoomed version is also attached to this message.

There is still a difference in the coordinates of the objects that should be in the same direction. For example, the X coordinate of the S19 column is 1860.7582 cm, while the X coordinate of the S37 column is 1860.95603 cm. The angle of the D axis is 270.011 degrees... Re-enter your objects including the axes .

I've fixed everything I can, but the problem persists. There are probably other places I missed but I couldn't find it. mel beams also give zg error and it didn't fix it no matter what I did. I wonder if this is a related issue with the nutcases or is it completely separate?

 

[Levent Özpak]

I fixed everything I could, but the problem persists. There are probably other places that I missed but I couldn't find it. Also all the foundation beams are giving zg error and no matter what I did it didn't fix. completely separate?

The problem is all about data entry... Soil safety stress value is 1.65 tf/m2 entered in Analysis Settings. I think it will be 16.5 tf/m2. Also, "automatic reinforced concrete design" line has been unchecked in Analysis Settings.