Hello there; First of all, congratulations on the new version. I would like to share with you some of the shortcomings I have seen, some of them will be the points I want to learn *The concrete quantity of a retaining wall I have solved does not coincide with the concrete quantity calculation I made by hand. I would appreciate it if you could check if you think I'm not wrong. *When I start a new one using the last settings, I cannot see the materials I used in the previous project. *Sometimes in project design, the program closes itself, there is no clear error message, this program gives a message like it terminated itself. Note: There is no hardware related problem on my computer. *It would be nice if a "Assign Default" button could be added to the Dwg/Dxf Export Options screen. *I think an automatic transverse tooth would be added after a 4 m gap is passed in hollow floor slabs. It has not been done yet. *Is there any improvement in drawing inclined beams as they are modelled? *When I say check the geometry after the building design, it gives a column-beam junction error for the beams in the outer frame. When I examine the building as a 3D frame, there is no problem in the column-beam junctions. *When I model and solve a system with ideCad6, which has no problem in solving with ideCad5, the columns do not save. The error message appears on transverse reinforcements. These are the ones I can think of for now, good works I will add more in time