German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish Hello, I have a project consisting of the floor, the 1st and the 2nd floor, with a 1 m sub-floor curtain on the raft slab. When I say "analyze the system", a warning message comes first: "more than one diaphragm is detected in the floors below" and "resolve the system with more than one diaphragm" does not cause any problems. B2 irregularities occur on the 1st floor, which is quite close to 50. I deleted the raft floor and recreated it, but I could not solve the problem. Where could the problem come from? I need to solve this project with a single aperture. I can't send the file, the size is big.. I would appreciate it if you reply as soon as possible..
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
"resolve system with multiple apertures" problem
- Thread starter mcoskung
- Start date
HakanŞahin
Administrator
Hi, It's hard to get help without adding the project. You can save the project by compressing it or you can upload it to one of the file access sites and give the link.
Hello, I uploaded the file..
You do not have permission to view link
Log in or register now.
Levent Özpak
Active Member
Hello, Due to the location of the D22 slab on the ground floor, there are multiple rigid diaphragm is detected. In order to solve according to a single rigid diaphragm assumption on the ground floor, select the tiles and click the object properties command. Check the option "Automatically generate rigid diaphragm regardless of connection". Good work"mcoskung":3ika6mhf" said:Hi, I have a project consisting of floor with 1 m flood curtain on raft slab, floor 1. 2. When I say analyze the system, a warning message comes first: " more than one diaphragm in the floors below When it is detected" and "solve the system with more than one diaphragm", there is no problem and there is also b2 irregularity, which does not occur, and when I select "create a single diaphragm in the floors", a number of B2 irregularities close to 50 occur on the 1st floor. I deleted it, I created it from scratch, but I couldn't solve the problem. Where could the problem stem from. I need to solve this project with a single diaphragm. I can't send the file. The size is large.. I would appreciate it if you could reply as soon as possible..