project errors

H

hebunyayik

New Member
I CAN'T CORRECT ERRORS IN GEOMETRIC CONTROL I'm NEW CAN YOU HELP? COLUMN GIVES BEAM INTERCEPTION FAULT I ATTEMPT 70/70 BEAM TO THE POLYGON COLUMN AND THE OTHER EDGE 60/70 GIVES ERROR ONLY GEOMETRIC CONTROL 70/70 I REMOVE THE BEAM 60/70 BUT ORAKONİŞE A LIQUIROME TRAVELER BUT HORAKONİŞTE A GEOMETRIC DRUM BILISIM, THE BEAM IS FIXED.
 
Hello, My Suggestions: --There is IdeCAD Demo V10.09, which complies with the TBDY2018 regulation, use it, --Do not enter the curtains around the stairs as one piece, watch the training videos. ideCAD Static IDS | Reinforced Concrete Curtain Drawing
You do not have permission to view link Log in or register now.
Ünver ÖZCAN
 
When I enter it as a curtain, it does not meet the regulation requirement, because the thickness length requirement does not provide the place where it should be 7, so I drew the polygon as a column, is that why it gives errors?
 
Hello
"hebunyayik":1m8i87u3" said:
when I enter it as a screen, it does not meet the regulation requirement, because the thickness length requirement does not provide the place where it should be 7, is it because I drew the polygon as a column, so it gives errors?
Click to expand...
The number 7 in the new regulation became 6. In this case, the program does not give an error, it gives a warning, you can fix it if you want, If it gave an error message, you should definitely fix it.
 
You must log in or register to reply here.
Back
Top