pleat on beams

[mhmt_ali]

I saw that in other programs they did not make piles in beams, can you give me information about how to solve beams without piling in the project I am doing in idestatics.

 

[Emrah YILDIZ]

Hello, In order to design without pillars, you need to intervene in the "Pillar Parameters" section in the Beam Settings, Static/Reinforced Concrete tab.

 

[YasinTezel]

I saw in other programs that they do not make pillars in beams, can you tell me how to solve beams without piling in the project I am doing in idestatics. or you can set the minimum pile bottom distance to 1200 cm in the Reinforced Concrete menu --> Parameters --> General reinforced concrete parameters dialog.