My project is crashing and closing during analysis!Can you take a look?

Y

YakupAltay

New Member
When I want to solve my project in semi-rigid diaphragm according to the mode combining method. It gives a Geometric compatibility error during the analysis. It seems that there are small angled objects as a warning in the geometric fitness check. But in my project, there is no error in the nodal points of small angled objects, I would appreciate it if you could help me urgently.
 
Re: My project crashes and closes during analysis! 0:26 ********************* CANNOT SOLVE SYSTEM ON LOADING "Modal".*************** ***** 0:26 Pivot error in matrix reduction. 0:26 Problem joint number : 22 0:26 Joint coordinates: X : 6.15 Y : 31.80 Z : 14.65 When the coordinates are followed, it is seen that the problem is caused by faulty beam connections at the junction of the A-7 axis. The corrected project is attached; You can use it or look at it as an example. Good work
 
You must log in or register to reply here.
Back
Top