mosque project

[sefa_26_68]

Teacher SA has us draw a mosque project for the thesis. In the mosque I built, a beam at a certain height was defined in the middle of the mosque and beams were laid from there to the columns, and then flooring was laid here. If you want, I will send the project I did. Thank you very much in advance..

 

[YasinTezel]

SA teacher has us draw a mosque project for the thesis. In the mosque I built, a beam beam of a certain height was defined in the middle on the middle floor and beams were laid from there to the columns, then slabs were laid here. Thank you. If you want, I will send my project to you. Thank you very much in advance..

Hello, draw columns, beams and slabs on the plan plane without considering the elevations. Since the slope directions of the slabs here are different, you need to incline them one by one. Click the "give bevel" command. Select one of the tiles, press the right button, press Yes to select all the surrounding elements. Specify the direction of the slope. For this, you can use the midpoints of the Outer and Inner Beams, as in the figure, while the Midpoint capture is active. Enter . Press OK to exit. Repeat this process for other tiles.

 

[sefa_26_68]

Mr. Yasin, did I define the beam in the attic correctly, and are the beams stuck in the beam from the columns in the middle beam correct? Could you give me information about such pressure-centered systems. Thank you very much in advance..

 

[YasinTezel]

Yasin, did I define the roof beam correctly? Are the beams stuck in the middle beam from the columns correct? Can you give me information about pressure-centered systems like this.. Thank you very much in advance..

Hello, I can help if you add your project.