Min Reinforcement in Beams

[Apocalpyse]

Hello, In beams, idecad automatically puts the min reinforcement as 2 mountings at the top and 2 flat reinforcements at the bottom as a result of the analysis. I want the upper and lower min 3 reinforcements. Is it possible to choose this as default? Top-bottom 3 reinforcements, if necessary, it should add itself again, I couldn't get anywhere by changing the min price. Instead of trying to fix these one by one, let's make an adjustment, let's get min 3 bottom 3 top, let's avoid labor problems Thanks

 

[Levent Özpak]

Hi, in the Beam Parameters dialog you can reduce the Maximum Assembly+flat spacing value. For example, 15 cm. You can do. Good work

 

[Apocalpyse]

I made 18, he set the value as 5 upper and lower in 65 hollow hollow beams, it was nice, but since he counts the pile as flat reinforcement, the lower reinforcement is missing 1 in the piled beams, but that is enough for me, thank you, take it easy.