German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
INCORRECT COLUMN/BEAM INTERCEPTION
- Thread starter shewger
- Start date
Hello there; The problem is that you have defined the elevator curtain, which should be defined as a group curtain, as a polygon column. Define the element seen in the attached screenshot as a group curtain. Beams cannot be defined between the two ends of U-type elements defined as polygonal columns! Best regards.
Hello there; After selecting the curtain pieces you want to group, right-click on them and enter the properties tab. There, just give a group name like "GP1" in the Group Name box. You can do this by selecting the same curtain parts on all floors from the perspective window at the same time, or you should do this by giving the same group name to the same curtain parts on all floors one by one. After the analysis, you can follow the design results of the group curtains from the Analysis and Design menu, under the heading Curtain Group. Best regards.
Hello there; If you pay attention, this message is given with the title WARNING. In other words, it may or may not be an error, but you, as the engineer who designed it, will decide. Namely; In your project, the curtains that do not meet the 1/6 condition are each part of the group curtain and there are other curtain arms that meet the 1/6 condition of the group curtain in the X direction, in this case there is no problem in your design. As of V10.17, this and similar group curtain parts that do not meet the 1/6 requirement are designed like the headboard area. See attached screenshot. Best regards.