German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Gives analysis error due to small angled objects
- Thread starter ÜNAL ÖRS
- Start date
Levent Özpak
Active Member
Re: analysis error Hello, The reason why analysis could not be performed in the project is the small beam piece formed at the junction of K22-K30 beams. If this beam part is deleted, analysis can be done. Some other notes; There is a floor edge object under the K20 beam. It would be appropriate to model K19-K20- beams as a single beam. I think there will be columns at the intersections of K20-21-42 beams. Good work
Levent Özpak
Active Member
Re: analysis error
The attached project can be analyzed"ÜNAL ÖRS":327tnkyb" said:thank you for your answer, but after correcting the error, it gave an error again