Dormitory project review

M

murat_859

New Member
Hello everyone, I am doing a summer internship at the University. I drew a dormitory project with İdecad. Can you review and correct my mistakes before submitting them to the school? Thank you so much in advance.
You do not have permission to view link Log in or register now.
 
Hello -- Process the stairs next to the elevator. (Then the errors in the geometry control will be removed.) --Place a mezzanine beam to support the stairs.(You can remove the floor beam attached to the floor.) --Place the slab supported to the beams between 10.00 m and 13.50 m for the elevator machine. --You can correct the errors in the columns (B) by centering the beams on the columns. MUST BE FIXED. --You should get the load-bearing system coefficient of 7 since there are curtains in the system --Check the wall loads are always the same --You can make the live loads 0.150 t/m2 on the ribs on the attic floor --Remove the wall loads on the beams in the attic floor. --Enter user defined live load on rib beams in normal floors.( .5*.35=0.175 t/m for 50 cm width) Ünver ÖZCAN
 
Thank you sooo much for your answers. But since I am still a student, I have no information about some of your writings. If possible, I would be very grateful if you could fix it on the project and post it. We have a lot to learn from people like you. Thank you in advance.
 
You must log in or register to reply here.
Back
Top