Center of rigidity and center of mass are not visible

[cyln]

take it easy everyone, I'm working on a project, but somehow my center of mass and rigidity is not visible, I will not see if it coincides or not.

 

[YasinTezel]

Hello, You may not have done the analysis. After analysis, it will appear on the plan.

 

[cyln]

Thank you, it did not appear because I had it analyzed without placing the tile. It was fixed. It's easy.

 

[ilhanyilmaz]

Hello, I want to learn something too, can we learn the distance between the center of gravity and the center of rigidity in idecad or is there such an option?

 

[cyln]

Greetings, I want to learn something too, can we learn the distance between the center of gravity and the center of rigidity in idecad or is there such an option? We expect our colleagues to enlighten us, so I was curious.

 

[Levent Özpak]

Greetings, I want to learn something, can we learn the distance between the center of gravity and the center of rigidity in idecad or is there such an option?

this I have no idea about the subject. Here you can find the difference between them by subtraction.

 

[cyln]

Hi, I want to learn something too, can we learn the distance between the center of gravity and the center of rigidity in idecad or Is there such an option?

I have no idea about this subject, we are waiting for our esteemed colleagues who have knowledge on this subject to enlighten us, and I was just wondering.

Hello, Distances of stiffness and center of mass from the origin point in structures with rigid diaphragms Analysis/Layer Parameters You can find the difference between them by subtracting them from here.

God bless you. Good work..