Beam slab edge overlaps

E

elifabus

New Member
Hello there; I want to cross the protruding parts of the project I'm working on with the tile edge. However, it gives the error "beam slab edge overlaps". So I'm having trouble splitting the beam. I would be glad if you help. Thanks in advance..
 
Re: BEAM FLOOR EDGE OVERCOME Add your project, or take a screenshot of the part you want to make. Also, describe where and where you are trying to draw the tile edge so that we can help.
 
Re: BEAM FLOOR SIDE OVERCOME I want to cross the balcony edge and the ledge under the K16 beam with the floor edge. I am attaching the project.
 
Re: BEAM FLOOR EDGE OVERCOME I was able to get tiles in the places you mentioned, there was no problem. The project is attached.
 
Re: BEAM TILE EDGE OVERCOME I was able to place tiles anyway, the problem is that when I place a tile with the tile edge, the geometry control gives the error "beam tile edge overlaps". I cannot solve this problem.
 
Re: BEAM FLOOR EDGE OVERCOME A few unnecessary slab edges have been drawn around the K1-K11 beam (I guess it was mixed with the 2D drawing), if you clean them, it will not give the warning.
 
Re: BEAM FLOOR EDGE OVERCOME As far as I understand, you made the D12 slab on the ground floor with the intention of laying a raft at -400 level, but this data entry is incorrect. You used the tile tiling command instead of mat tiling. For this, you have to switch from formwork plan mode to architectural mode. Then you must enter the command mat tile edge and describe the tiling (mat tiling). Erase the existing tile edges as well.
 
You must log in or register to reply here.
Back
Top