About the Basement and Base Level

Y

yusufgok

New Member
Hello. I cannot adapt the elevations in the architectural project in idecad. My basic upper level is +0.00, my basement level is +0.80. The ground floor starts from +0.80, and the floor height of the ground floor is 320 cm. The other floors are 295 cm. In another matter, do I have to work together with the basement walls and columns or should I leave a joint gap? Thanks for your help. PROJECT :
You do not have permission to view link Log in or register now.
 
Hello, In the Floor General Settings dialog, enter the Base Level as 0 (zero) and add the basement height to the ground floor height and adjust the ground floor height as 4.00 meters.
You do not have permission to view link Log in or register now.
Do I need to work with the columns and basement walls together or should I leave a joint gap? Thank you for your help.
Click to expand...
In practice, basement curtains are usually poured with columns. Therefore, they should be run together. Good work
 
Thanks for your answer Mr. Levent, But the staircase with ground floor landing is not at its level right now, if I want to solve it together with the building, how will I attach the last step to the beam. In another question, after the analysis, I see that there is a lot of deformation on the nave of my staircase with landing. If I define the landing beam, will it be inconvenient when considering the short column effect?
 
You must log in or register to reply here.
Back
Top