Hello, the ladder is in the attached There is also a similar ladder at the link below:"ide64":3vvhu518" said:I already know these, I can't create a step on the landing.. I have problems with the calculation, the program gives an error when I create it, although the image is correct, can you help with such a model that you are sure of the correct calculation
You learn to read the shell results. After that, you can comment on the moments. If you don't know how to interpret the shell results, the program will give you the reinforcement areas on the bottom surface of the plate and the top surface of the plate in both directions. does not contain a cross-section. If you add a cross-section from the line that says "123 123", it will be clear what it is, how the reinforcement appears to be placed. Let's figure out how you combined two landings at different elevations, then we'll put them in. Good luck with."ide64":2djy9be3" said:If the distance between two exits is 27.5 cm, a step will fit there naturally, which can be defined from a staircase17. I know this.. I think you are not looking at the architecture that will be 5 cm between two exits and 2.5 cm in the middle of my step.. .. you will say that you can do this again from the staircase17, after you do it, the floor under the step changes 5 cm in width and 10 cm in length, what kind of equipment do I get there, let's say we have the equipment done, the program does not give moments, it gives nonsense moments. Should we say this and rub it?
German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish