German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish Karmnl1158
New Member
You do not have permission to view link
Log in or register now.
Screen ratio error after analysis
- Thread starter Karmnl1158
- Start date
Re: curtain ratio error after analysis urgent help Hello, when the calculation is done: K114 beam of the 9th floor gives an error because the joint point is fixed in the beam. When the nodal fixing is removed and the reinforced concrete calculation is made, there is no error. NOTE: WHEN MAKING ACCOUNT IN THE NEW PROJECT, DO NOT CALCULATED BY FIXING THE NODE POINTS. Take it easy Unver ÖZCAN
Karmnl1158
New Member
Re: curtain ratio error after analysis urgent help First of all, I would like to thank you brother Ünver, you are like Hızır 
tmm brother, I will pay attention Brother, there is no problem in getting analysis, the report is correct, there is no problem in geometry control, but; After receiving the report, it checks the screen ratio, it gives an error with a red tick mark, ünver brother, I encountered it for the first time, I would be glad if you could help me.
tmm brother, I will pay attention Brother, there is no problem in getting analysis, the report is correct, there is no problem in geometry control, but; After receiving the report, it checks the screen ratio, it gives an error with a red tick mark, ünver brother, I encountered it for the first time, I would be glad if you could help me.YasinTezel
Member
Re: screen ratio error after analysis urgent help Hello, Remove Screen ratio report before importing optional reports. The curtain ratio report is a check on tunnel formwork systems.
Karmnl1158
New Member
Re: screen ratio error after analysis urgent help Thank you Yasin brother, thank you very much, have a nice day