REINFORCED MINARE

E

Eralp Özer

New Member
I tried to solve it in the form of reinforced concrete minarets using curtain and polygon, but I can't make the two of them work rigidly. Is there a way to run both together? Since I can't change the location of the joint in the polygon column, the details in the overlapping columns seem to work differently on the floors because the joint points are different. How can I change the nodes and give them from the same point?
 
I also tried modeling with just a polygon column, but it seemed very unhealthy to me. What are your suggestions? Since I can't overlap the node points, I guess I can't work together exactly because the polygon column sizes on the floors differ in the floors.
 
Hello, There is no possibility to define a vertically inclined curtain, hollow polygon column with variable cross-section in the program. In the static part of your minaret, I can recommend that you model it as a rectangular wall without considering the changing sections, consider the changing sections as coatings in the system and give the coatings as an additional load.
 
You must log in or register to reply here.
Back
Top