Panel Join Problem.

[Bolvadinim]

Hello. While making a floor plan in our architectural project, we need to put curtains in some places instead of columns or polygon columns (door, window with a hollow panel). However, in this case, defining the space and plaster combinations in panel-wall combinations become a problem. We have mentioned the related problems in the forum before. Something needs to be done to solve it.

 

[admin]

Can you add example cases (with a description of the project and where the problem occurred) to the forum or send it to our technical service?

 

[Bolvadinim]

Could you add example situations (with a description of the project and where the problem occurred) to the forum or send it to our technical service?

Hello.. Can you share a sample project in the forum about definition, curtain and wall intersections, plaster combinations?

 

[Arzu Dural Gök]

Hello, with the create zone command by selecting a contour, the zones with a curtain on the border can now be created. Panel plaster is in the job list as you specified. You can overcome this problem by drawing a wall instead of a panel, or by drawing a panel and plastering with 2D possibilities.

 

[Bolvadinim]

Hi, you can now create spaces with curtains on the border with the create space by selecting contour command. Panel plaster is in the work list as you specified. You can get over it. ... Thanks

 

[ofis2a]

It is still not possible to plaster the panels. Any progress on this?