ideCAD Steel 8.102 issues

E

eraycnar

New Member
Hello; I have 2 problems in the attached file. The first anchors are not visible in 3D drawings and production drawings. I think there is a mistake in the drawings. The 2nd side shows 0 column foot calculations. The program is stopped when I press the design entries. I present to your information, I wish you good work...
 
In the 8.103 version update, the PMM values that increased as the analysis in Krenli systems improved and the anchors are seen in the drawings. However, the colon foot problem still persists. The combination D/K ratio is 0.00 and the program is closed when the design report is pressed.
 
You must log in or register to reply here.
Back
Top