I'm Getting Ground Safety Stress Error Help

U

uzuncayir

New Member
I have done my best for the project. I have no faults in the beams, but I am getting zk in 3 columns and zg in the foundation. I could not find a solution if I did. Is there anyone who can help?
 
Help? because he chose the columns as fi 8, he used too much reinforcement and there are still zk errors in 6 columns. Thank you very much for pointing out the changes. I'm bothering you too.
 
Re: I'm getting a Safety Stress Error on the Ground Help? Hello, I don't see a Zk error. (no error messages.) If the same situation persists, update the Demo program. In the attic floor, the slab live loads were reduced, the wall loads on the beam were removed, k33 70 cm was built in the 1st basement floor. Unver ÖZCAN
 
You must log in or register to reply here.
Back
Top