How to correct the font of the detail?

A

ammer

New Member
hello dears
in the below image for the flat slab reinforcement,i want to get the same font size.....how can i do it?
 
ammer":2co5l56x said:
hello dears
in the below image for the flat slab reinforcement,i want to get the same font size.....how can i do it?
Click to expand...
Hi Ammer,
Which text you want to make same size with which one's size? can you explain your question more?
 
ammer":37nozesi said:
hi hakan
the two total length that i pointed in the red line....
Click to expand...
Hi Ammer,
Give same value on both "steel text" and "Total reinforcement lenght" on" Drawing Properties", which you will see before drawing framework plan. See the picture below.
 
ammer":2z72nm2l said:
dear hakan
i mean that the text 1 is smaller than text 2
how to get same height font
Click to expand...
Hi Ammer,
Text heights of auxiliary reinforcement bar might be automatically scaled to along bars to fit small reinforcement bar. You may change them manually by exploding block texts after drawing framework plan.
 
ammer":18y0rtj6 said:
hi hakan
it was forming automatically .....i didnt edit it.
Click to expand...

Hi Ammer,

You need to edit after drawing formwork plan if you want to make same size.

1. Select the text.
2. Click right button of mouse on it.
3. Select "explode" command from appearing menü list

4. Explode Type dialog will be appeared.
5. Select "explode all" and click Ok.

6. Now you may select texts that you want
7. Click right button of mouse on text.
8. Select "Edit text" command from appearing menü list.

9. Change text height from there and click ok.
10. change height for per text that you want by doing 6-10 steps.
 
You must log in or register to reply here.
Back
Top