Distribution Irons in Panels

sabit

New Member
Merla; The panels that we defined in the basement floors should go into the columns where the distribution irons meet. As a result, panels are binding elements like beams in one place. For example, in water tanks or basements where there is a soil load on one side, unwanted separations occur between the column and the panel over time. my question is will this be fixed and what are your friends' comments on this issue? I wish you good work..
 
The column application made in the added 6.01 was great. I wonder if there are alternatives regarding the number and type of column stirrups in this version?
 
In the new version, different stirrup types will come, but which types they will be is not certain at the moment.
 
It looks very nice.. It would be nicer if the reinforcement diameters (inside painted circle) were drawn a little exaggerated. When we give the pen thickness, the existing reinforcement circle looks like a point in the application.. The placement of the column reinforcement was not noticeable. Improving the drawing possibilities will give the program a different strength. Thank you İdeYAPI..
 
Mr. Bolvadinim, we have increased the diameters of the longitudinal reinforcement display compared to the old version, as you requested before. Now the reinforcement placement is more specific. Since this picture was taken as a small screenshot, it was not very clear.
 
In your project, is there a need to use S-shaped crossties on some panels and L-shaped crossties on others? Or are you using one type in the whole project?
 
I realized when you said it, I hadn't noticed before. At 6.0053, curtain distribution equipment does not go into the column. It is said to be in the previous version. I guess this will be fixed in next versions too....
 
Back
Top