Deflection and ground safety negative error

E

engineer5378

New Member
THE PROJECT LINKED BELOW IS THE BOARD PROJECT AND IT HAS BEEN APPROVED. I CAN ACCOMPLISH THE DIFFERENCE ERROR BY CHANGEING THE BEAM HEIGHT, BUT THE BOARD DID NOT ACCEPT THE VIEW FROM THE FRONT ABOVE 25 CM, I MADE IT HORIZONTAL FROM IT BUT I CANNOT SAVE IT. IF THE GROUND SAFETY IS NEGATIVE ERROR, I THINK I MADE WRONG SETTINGS, BECAUSE I CANNOT SAVE IT EVEN IF I MADE AN AMPARTMENT AND ENLARGED THE SECTION. I'M SOLVING A PROJECT FOR THE FIRST TIME IN IDECAD 10. I'LL BE HAPPY IF YOU CAN HELP ME. PROJECT LINK
You do not have permission to view link Log in or register now.
 
Re: DEPLOYMENT ERROR AND NEGATIVE GROUND SECURITY ERROR Hello. My suggestions: --The width of the beam should not exceed the width of the column it is inserted into. --As the program warns in the geometry control, you cannot make the beam heights less than 30 cm. --Assuming the wall is loaded on the K19 beam; Make this beam a reverse beam so that it rises 25 cm like 30/50. --Do not get stuck in a beam that is narrower than the width of the K19 beam on the upper floors. be the same width. --Remove the negative control in the ground control or enlarge the foundation a little as the columns come to the corners, --Increase the additional raft reinforcements, --Increase the dimensions of the columns a little for the relative storey drifts error and balance them, --Correct the B errors, Ünver ÖZCAN
 
Re: Deflection ERROR AND NEGATIVE GROUND SAFETY ERROR Thank you very much, UnverBey, for your answers. I only have the K19 beam problem. I am aware that there is a wall load on it, but the brick will not be built, a railing will be built and the protection board wants it to be seen from the 25 cm front. I couldn't fix that problem.
 
Re: DEPLOYMENT ERROR AND NEGATIVE GROUND SAFETY ERROR If railings are to be built, remove these loads and analyze.
 
You must log in or register to reply here.
Back
Top