Defining Zone Boundaries

[serdagi]

Hello, we need to make approximate cost calculations for a project that we have just started to draw. However, we are experiencing difficulties in the boundaries of the neighborhood we have created. There were some suggestions on the

You do not have permission to view link Log in or register now.

link that shared the same problem, and we applied them then. but it couldn't. Since the project was small in size, we were able to do the quantity transactions separately. However, doing this separately in our new job may take longer than the project. I am sharing our project, which we are at the beginning, in the attachment. For example, when we choose the M06 space, it seems as if it is selected on the walls in J and L and some other axes, naturally the space area is calculated as large. good work...

 

[cansahin]

Good work, if you are talking about a problem with Zone 1 areas, there does not appear to be a problem with area calculations. 2. If you are talking about showing the location on the plaster in the drawings, you can select the drawing order/send to the background option by clicking the right mouse button on the location. 3. If you are talking about not considering plasters in the area calculation of the zones, you can mark the "Consider plasters in the area calculation" tab in the general settings of the zone. If the problem is something other than these, you can call our Bursa office and get technical support. Good luck with.