cut-off safety

C

cüneytsözer

New Member
In version 6.0011, columns that do not recover shear safety are not visible in the column reinforced concrete table (b's in the stirrup section). but here it says insecure, not encircled. Also, the geometry control icon is gone.
 
Hello, In the 6th version reports, the warning criterion has changed in the column-beam junction safety control, as in the other controls. From now on, the user is informed by placing an arrow and a cross if there is any negativity in the regulation controls made in the reports. If there is a negativity in the column-beam junction in any column, at the end of the related report, &#39;Control(And <Vmax)' sütununa çarpı işareti konuyor.

Geometri kontrolü ilerleyen versiyonlarda daha geniş kapsamlı çalışacağı için şimdilik kaldırıldı.
 
In version 6.0010, we could see columns that do not provide shear safety in reinforced concrete, and &quot;b&quot; was written on the stirrup column. We cannot see the columns that do not provide shear safety in 6.0011 in the column reinforced concrete results. We will see if we can control these only by getting a report.
 
Mr. Cüneyt, we have made a change in version 6.0011 so that such negative situation warnings are indicated next to the employee&#39;s name. (For reading stirrups etc.)
 
You must log in or register to reply here.
Back
Top