German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish I made a curtain on the exterior of the building... it doesn't see the beam coming out of the end of the curtain as a console beam... I changed the console direction from the change section. Again, it doesn't see the beam coming out of the panel end as a console beam... I would appreciate it if you could give CV
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Cantilever beam protruding from the curtain
- Thread starter adem40
- Start date
Re: cantilever beam....
"unver":31cxrcuc" said:Add your project.
Re: cantilever beam....
does not see all cantilever beams on the panels as consoles.. you can look at any console beams.."unver":1s6i8djk" said:How many beams does it not see?
Re: cantilever beam....
"unver":2cgt7fes" said:I see it too. Check if there is a closed place in the layer settings. When I look at its accessories, it doesn't show up as a console...
Re: cantilever beam....
"adem40":3lh5cgfz" said:I don't think I could tell, when I look at the console beam reinforcements coming out of the curtain end on the exterior, it does not appear as a console... In the 7.22 version, the console beams coming out of the curtain were showing as consoles in reinforced concrete settings. ..it doesn't appear now."unver":3lh5cgfz" said:I see it too. See if there is a closed place in the layer settings.
Re: cantilever beam.... You can check the beam moment from 3d frame analysis, if the moment is zero at the free end, it is perceived as cantilever. The absence of the phrase "console" in the reinforced concrete>beam>rebars tab does not mean that the beam is not a cantilever. Good work. Sent from my SM-N920C using Tapatalk
HakanŞahin
Administrator
Re: cantilever beam.... We can say that the cantilever is an element that has a moment (negative moment) that forces it to pull the top of the section, but that moment becomes zero as it goes to the other end. Addition is placed on the support according to the negative moment, the extension is extended to the end of the console. In the 3D mathematical model, there is no such thing as a console. According to the moment diagram, we call it a console. As an exception, the program does not call it console in elements that are supported on the screen. Its naming as console is among our notes. However, it automatically selects the required reinforcement according to the design moments. You do not need to make any interventions. You can verify this by examining the moment diagram of the beam and the choice of reinforcement. Example beam moment diagram. A total of 2fi16 mounting on the right support and 6fi16 upper right addition meets the upper right moment of 27.88 tf. On the left support, the 2fi16 assembly meets the upper left design moment. Example beam reinforcement selection: Example beam reinforcement drawing: If you want to edit the drawing of this beam as cantilever, you can install 8fi16 and remove the upper right addition.