Arrangement of the mold plan. Unreadable texts.

F

FIRAT

New Member
When I created the mold plan to examine the reinforcements after drawing, I saw some texts that I could not understand on some of the reinforcements. I don't know if the texts overlap or the reason is something else. 5u5rwd/12.bmp.html]http://s3.file.tc/server6/5u5rwd/12.bmp.html[/url]
 
Friends, the reason for this problem is that the reinforcement length and the text indicating the reinforcement diameter overlap. When I reduce the size of the reinforcement length from 12 cm to 6 cm in the drawing settings, it only saves, if I do this, the text size of the reinforcement becomes very small. What do you think should I do? is there any other solution? Wouldn't 6 cm be too small in the project, so it would be hard to read? I need your urgent help
 
You cannot leave drawings like this. Reducing the font size is also not the right solution. If you are going to take 1/50 drawings, the legibility of the text decreases below a certain size. That's why it's up to you to make the drawing understandable. With the Quick move command, you can place the text in a suitable place in the drawing without breaking the blocks. It is not possible for the program to arrange everything.
 
It is not likely to be transported because, in addition to the fact that the diameter of the reinforcement and the length of the reinforcement are intertwined, they are also very close to the information of other reinforcements.
 
You must log in or register to reply here.
Back
Top