about torsion

[iek58]

hello, there are long curtains on basement 2 and basement 1 floors due to soil load, so RM and KM are too far away in B2 and B1. There is no problem with RM and KM on 3 floors of Z and above. There is a rigid floor acceptance option in the program, but how warm are you to using this option? I would appreciate if you add your other suggestions about the project, Regards

You do not have permission to view link Log in or register now.

 

[unver]

Hello, My Suggestions -- Correct what is given in the geometry control, --Add the ladder and solve it together with the system --You can reduce the live loads on the roof, remove the wall loads, --The edited project is attached by Ünver ÖZCAN

 

[iek58]

Hi My Suggestions --Fix the given in geometry control, --Add the ladder and solve it together with the system --You can reduce the live loads on the roof, remove the wall loads, --The edited project is attached Ünver ÖZCAN

for your attention Thank you very much Mr. Unver, -what I really want to learn from your experience is that you made the assumption of rigidity in one direction in Bodrum 2. What are the pros and cons of doing this. -You modeled the curtains in the x direction only as shells. What is the reason? -How did you make the file that I uploaded as 60 mb to 2 mb? Regards...

 

[unver]

Hello

-what I really want to learn from your experience is that you have assumed rigidity in one direction in Bodrum 2. What are the pros and cons of doing this.

--Since there are curtains on the right, left and middle of the building, in this direction I assumed it has rigidity,

- You modeled the curtains in the x direction as shells only. You did not select "basement/curtain that does not continue on upper floors". what is the reason for this?

--I didn't interfere with the curtain modelling, it will be active with the model as a shell, flooding/ curtain that does not continue on all floors will be passive,

-60 mb, how is the file I uploaded as 2mb did you ?

-draw an empty beam on any floor, -make calculation, -The program gives an error message, -close the calculation, -save by deleting and compressing the beam or upload the project with save. Ünver ÖZCAN

 

[iek58]

thanks

-- Since the building has curtains on the right, left and middle, I accepted that it has rigidity in this direction,

I placed curtains on the left and back of the building in plan view, to balance the center of stiffness in the middle and right What could we do to solve this problem if I had not placed these curtains? In B1 I just placed a curtain behind it

--I did not interfere with the curtain modelling, it is active with the model as a shell, flooding/ curtain that does not continue on all floors will be passive,

I will keep the model active as a shell. but don't I need to activate the "flooded / curtain that does not continue on all floors" option for curtains that do not continue on the upper floors? Best regards...