German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish Hello, it gives a weak floor error in the project with a half-floor basement. I made two different foundations on the ground floor and basement, but my first stage foundation project was correct, I don't know and I couldn't solve the problem even though I increased the thickness of the foundation, can you help me?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
weak floor
- Thread starter MüHenDiS
- Start date
YasinTezel
Member
Hello, The project you sent is not completed, there are empty floors in the model and none of the floors are defined. First of all, finalize the model because it is controlled by rigid diaphragms in the earthquake regulation controls. Since there is a sudden decrease in section in a half-floor basement, it is possible to get a weak floor error. Do the checks mentioned in the forum page below.
You do not have permission to view link
Log in or register now.
Do not include the elevator shaft in the model. Check out the attached forum page.
You do not have permission to view link
Log in or register now.
The final version of the project is attached 1- it gives a punching error on the so8 s09 columns, how can I fix it 2- what should I do for the elevator tower when only one side of the elevator is curtain, because I can't assign different wrinkles to the floor on the last floor and should I define a separate floor for the elevator tower? 3- When I support the ladder, when I analyze accordingly, it does not analyze, it says check the system, what should I do? can you help me? Thanks.