German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish Mr: IdeYAPI officials and users; In the attached file, the analysis cannot be continued due to the "jacobin error" during the modal analysis phase. Although we did the checks, we did not see any problems in the nodal junctions. We scanned by deleting the carrier elements, which are likely to be a problem, one by one but in vain. In short, we need your help. Thanks in advance... Basics: We are using Windows Vista Ultimate x86. RAM: 3GB DDR3. MS Framework 4.0 is installed. IdeSTATİK 6.53 is installed. Project data entry and analysis settings: NOT COMPLETED 16 years with ideSTATİK
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
UNRESOLVABLE JAKOBEN ERROR
- Thread starter canlarins
- Start date
Levent Özpak
Active Member
Hello, -Some of the foundations seem to be not connected to the panels and columns in your project. -The P01 and P02 panels defined on the ground floor turn into a single panel on the basement floor. From a static point of view, such a panel can be entered. However, it would be appropriate to enter the P01 and P02 Panels in the basement, in order to ensure that the condition specified in Article 3.6.2.2 of the Regulation is met and the curtain end zones are formed on the 1st basement floor. Article 3.6.2.2 In buildings where the rigidity of the basement floors ƒcompared to the upper floors …is very large … in buildings where the surrounding shears are located and the basement floors work as a rigid diaphragm … in the horizontal plane, the magnitudes Hw and Hcr go up from the ground floor slab. will be taken into account. In such buildings, the critical height of the curtain wall will be further extended downwards at least along the height of the first basement floor below the ground floor -Likewise, the S09 column on the ground floor must also be entered on the Basement Floor. -one. In the D02 tile on the first floor, the gap must be created using the tile edge command. Good workWe didn't see any problems with the node joins even though we did the checks. We scanned by deleting the carrier elements, which are likely to be a problem, one by one but in vain. In short, we need your help. Thanks in advance...