Tick intervals

Y

yunussacikk

New Member
For my project that I sent to imo....weave gaps in columns and curtain head areas 25*fi etr. it says it must meet the condition... I don't fully understand the condition. If my stirrup diameter is 8, do I have to throw crosses at 25*0.8=20 cm intervals....I think the cross-ties in the columns are not shown in the column application..I uploaded the project to witransfer
You do not have permission to view link Log in or register now.
 
Re: crossties intervals Hello, in the program Tdy 2007 item 3.3.4.1 figure 3.3 specified in the max. The cross-ties gap control is done for the columns. In the project, the stirrup diameter is 10. Accordingly, max. The cross tie spacing can be 25*fi=25 cm and the cross tie spacings in the columns meet this condition. In the curtain end regions, cross-ties are not automatically controlled. In places that do not meet the 25fi condition, editing can be made using the kiroz command. Note: I suggest you model the P06-P07 curtain, which is between the 2-6 axes in the project, as a single piece using the "Combine" command in the Curtain auxiliary toolbar. Good work
 
You must log in or register to reply here.
Back
Top