The program closes when receiving the ground floor beam opening

M

mehmet2015

New Member
The program crashes while the ground floor is getting the beam opening. what should I do. Note: No errors were detected in the geometric control and analysis.
 
Re: The problem of getting idecad static beam expansion
"mehmet2015":1erl9e7m" said:
the program crashes while getting the ground floor beam expansion, what should I do. Note: There was no error in the geometric control and analysis.[ /quote] Hello If you attach the project file, we will review it.
Click to expand...
 
Re: The problem of getting idecad static beam expansion In the project, there is a zero-length K08 beam piece on the right side of the K07 beam on the ground floor. If you delete this beam and analyze it, you will be able to get beam expansion. Note: It would be appropriate to define the beam between the columns S13-s06 as one piece. Good work
 
You must log in or register to reply here.
Back
Top