stair landing problem

I

ibrahimhalilaydoğan

New Member
good day ... in a project with a 1.5 m floodplain, I created the stairs at the zero level of the entrance, but there was a problem on the landing, I could not put it on my floor. I would appreciate your help. have a nice day.. it doesn't fit because of the size, the link is below ...
You do not have permission to view link Log in or register now.
 
Hello, You can create the intermediate landing slab by drawing the slab edge limiting the slab a few cm inside, not under the beam on the upper level, as in the attached example. Also ; Beams were not drawn on the edges of some slabs in the project (Example D02-03-04-05-06). The slabs detected the lower level panels as edges. You should correct the errors that give warnings in the geometry control. Tile edges should only be drawn on the blank edge. The drawing of the upper level beam and floor system in the basement curtains after the creation minimizes the errors in the data entry. In addition, if the sub-floor curtains are not to be divided by the objects at the upper level while drawing, the divide line can be inactivated by intersections in the auxiliary toolbar. Good work
 
Incompatible file version. It says to install an updated program version to open this file.. It didn't open the plugin you sent. Now, if I take a separate floor, 1.5 meters, 1.5 meters from the ground floor, wouldn't it be better if I take all of them there? Can we clear up the confusion like this? In order to minimize the mistakes in the basement, do you suggest that I build the basement curtains after I have completed all the elements of the floor we are in?
 
You must log in or register to reply here.
Back
Top