sprout lengths normal layered / basic

[profesyonel]

I basically want to set the sprout lengths as 75q on the normal floor. I can choose the anchor length from the general reinforced concrete parameters, but how can I change it separately for the foundation and the normal floor. thanks

 

[Levent Özpak]

Hello, There is no such option in the program since the same criteria are valid for the column shoots in the foundation and superstructure in the regulation. Good work

 

[2m proje]

Hello there; While I agree with Mr. Levent, I can make the following suggestion; You can get the drawing by setting the sprout length option in the General Reinforced Concrete Parameters to 75Ø when taking the foundation drawings, and 60Ø when taking the drawings for normal floors. Important Note: This option will not work if you are importing All Floors together when importing column vertical expansions. For this, you need to take the vertical expansions of the columns by layering. Thanks to Levent Bey for this reminder. Best regards.