small angle object

[shewger]

I threw an angled column automatically after I cast an angled axis in the project. But after throwing the beams it says small angle object. When you grab the ends of the columns with the CTRL command and throw them, it says unsupported beam? I will be glad if you help

 

[Levent Özpak]

I automatically added an angled column after I cast an angled axis in the project. But after throwing the beams, it says small angle object. When I grab the ends of the columns with the CTRL command, it says unsupported beam? I would appreciate your help

Hello , The "small angle object" message in the geometry control is a "warning" message. If the objects you are modeling also have that angle in the project, you don't need to consider the warning. This does not prevent you from solving the project. Good work

 

[shewger]

thank you. It went very well