German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish yunussacikk
New Member
hello, in the control of 7.11.3, the axles that do not save are printed in the reports, but no warning is given when we receive the report.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Slab tension control 7.11.3
- Thread starter yunussacikk
- Start date
YasinTezel
Member
Hello. It is among our notes that these errors are shown on the report page where the faulty objects are listed and in the reinforced concrete dialogs.
yunussacikk
New Member
what is the reference point of the coordinates printed in the reports in the tensile stress control.
YasinTezel
Member
The location can be determined by following the X and Y coordinates in the coordinate box on the plan.