Section line command issue in 7.015

[buzadaM]

When I get the formwork plan in version 7.015, the "section line" command is disabled (passive) so I can't take a section in the formwork plan. In order to get a section from the formwork plan, I need to select the "create mold/complete plan section" option, I don't like this method at all, it breaks my axle lengths in version 7.014 There was no problem, can this command be activated again?

 

[Levent Özpak]

In version 7.015, when I get the formwork plan, the "section line" command is disabled (passive) so I can't take a section in the formwork plan, I need to tick the "create die/complete plan section" option from the formwork settings settings. I don't like it at all, it spoils my axle lengths. There was no such problem in version 7.014, can this command be activated again

Hello, -Create formwork /base plan section- line is marked, but if the formwork plan is taken from the box with the [/b] line marked Even the -Mould/Foundation Plan section command- under the Drawing Menu is active. You should also have it active. This command is inactive while in floor ceiling mode. You may have accidentally tried to run the command while in floor ceiling mode. If not, contact us by voice Let's provide remote access to your computer and perform due diligence.

 

[buzadaM]

I moved that command to the toolbar, it becomes inactive on my tollabar. I think I moved another command with the same icon.

 

[buzadaM]

yes, the problem is solved, I have the problem, I moved another command with a similar icon to the toolbar