Retaining wall

T

teknikisler

New Member
In the attached retaining wall project, there are two retaining walls of the same cross-section, one 690 cm high and the other 390 cm high. When I analyzed the retaining wall with a height of 690 cm, the one with a height of 390 cm does not. Shouldn't it be reverse? Or is there something I missed?
 
Re: retaining wall Hello, solve the retaining walls of 590 cm and 390 cm separately, there are insufficient places in both solutions, you must balance. Unver ÖZCAN
 
Unver teacher, I solve it at Ide 7. 590 saves, 390 gives slip safety error. It seems odd to me that the higher retaining saves when all values are the same except for height. Otherwise, I will not apply this retaining wall, I gave it as an example. It seems to me that there is such an error. If there is no error, I could not understand why.
 
Hello, I recommend you to make calculations using the latest (8.62) version, since in version 8 "Giving the controls in the reinforced concrete dialog of the retaining wall" is made. Unver ÖZCAN
 
You must log in or register to reply here.
Back
Top