German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish pelinagcan
New Member
This error does not go away, I would be happy if you check it
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Relative story drift error
- Thread starter pelinagcan
- Start date
Your wall loads are 0.5 t/m2 more than necessary, you should take it to a reasonable level. Your columns should be 30/30 minimum sizes, 30/50, 30/60. Your staircase is out of the stairwell, the landing and the inclined arms are unrelated, you should fit the ladder properly, associate it with the floor covering and introduce all the stair support areas, have a good sahur.
pelinagcan
New Member
Thank you for the situations you mentioned, I fixed them, still giving the same error.
HakanŞahin
Administrator
Hello, In the earthquake wizard, the information given for the structure coordinates and the DD3 seem to be incompatible. You must give the correct values to the program."pelinagcan":2h8bv5mc" said:this error does not go away, I would appreciate it if you check it out.
pelinagcan
New Member
where is the mistake
HakanŞahin
Administrator
The values you added are for DD2. For the relative floor drift calculation, you also need to give the SS and S1 information of DD3 to the program as I showed in the screenshot in my previous message. You can get this information from AFAD's map.
pelinagcan
New Member
thank you you have been very helpful.