Reinforcements of polygonal floors

[iek58]

hello, we have polygon flooring as seen in the attached picture. according to my control, the program equips squarely to center where the reinforcement axis (1 and 2) is shown. but the reinforcements are short on the long sides of the slab. on the short sides it stays longer than it should. I learned how to define an account axis in an L-shaped slab (

You do not have permission to view link Log in or register now.

) from your video . So how can we retrofit this amorphous slab? respects

 

[YasinTezel]

Hello, there is no possibility of variable size reinforcement in ideCAD. We have notes as request. In case you pass the calculation axis through the middle of the slab, the reinforcement length is taken as the average and gives an accurate value in the total quantity. My advice is to show the max and min values for this reinforcement, eg. L length calculated on the reinforcement in the form of L= 300 ~ 400 (Variable) can be written. If you are giving a quantity table, show these values in the quantity and reinforcement cutting table, so that the reinforcements are not cut to the wrong length while cutting.

 

[iek58]

Hi, there is no possibility of variable length reinforcement in ideCAD. We have notes as a request. If you pass the calculation axis through the middle of the slab, the reinforcement length is taken as the average and it gives a correct value in the total quantity. For example, L= 300 ~ 400 (Variable) length calculated on the reinforcement can be written. If you are providing a metering table, show these values in the quantity and reinforcement cutting table, so that the reinforcement is not cut in the wrong length.

thanks to the requests section, column shoots and Could you also add entering the root sprouts in separate sizes? (so we can make one 100 cm and the other 120 cm)