REINFORCEMENT LENGTH

[Kemal Baş]

As an example, 17m iron length is seen in the reinforcement drawing among the formwork plans. Since the longest iron we will use in the field is 12m, shouldn't this situation, which is not suitable for market conditions, need to be corrected? If there is any solution to this problem in the program, I am waiting for your help. Good work.

 

[HakanŞahin]

Hello, In general, the length value related to the maximum reinforcement length can be entered in the Parameters/General Reinforced Concrete Settings dialog. (Combine shorter reinforcements line). This value is 1200 cm by default. Check if the value is entered as 1200 cm. If your slab is a single, large-span slab, there is no rebar length control for slab pleats (drawn in one go). Alternatively, you can design the floor as top flat + bottom flat, or you can arrange the floor system to be less than 12 meters.