Raft basic additional accessories

[abaci09]

On the raft basis, the x, y coordinates of the locations of the additional reinforcements and the width are given under the subject of raft flooring reinforced concrete. However, when we receive the drawing, only additional reinforcements are given. I find the locations of the additional reinforcements and the area where they are valid by entering the x,y values one by one and transfer them to the drawing. The area where the additions are valid Is it transferred to the drawing by the program with dashed lines or is there a setting?

 

[proisa]

I'm following a path there, maybe it will be useful for you. For example, according to the picture you added; In the 21fi14/20 supplementary iron, the validity distance of the total iron is 20x20 = 400. If you offset half of this value to one side of the iron and the other half to the other side of the iron by centering the additional iron, the area where the iron comes from will be revealed. Of course, it's best if the program gives...

 

[mhanifiata]

I see that the need for additional reinforcement area does not change when the raft increases the area by tightening the base between the main axle reinforcements or increasing the diameter and increasing the area. is this normal?

 

[proisa]

I see that the need for additional reinforcement area does not change when the raft tightens between the main main axle reinforcements and increases its area, or when I increase the diameter and increase the area. Is this normal.

It changes when I lock the reinforcements and reanalyze...

 

[mhanifiata]

in fact, when the main reinforcements are changed, it should change without the need for analysis.

 

[3428]

I'm following a path like this, maybe it will be useful for you. For example, according to the picture you added, the validity distance of the total iron is 20x20 = 400 in the 21fi14/20 supplementary iron. If you offset half of it to the other direction, the area where the iron comes from will be revealed. Of course, the best thing if the program gives it...

Unfortunately, it's not like you said, Sta4cadte does not distribute the additional reinforcements in half as you say. It would be a wrong application if we do it as you say. İdecadin is a solution to this. If there is a method that I do not know, I would love it if they share it with us.

 

[Levent Özpak]

I'm following a path there, maybe it will help you. For example, according to the picture you added; In the 21fi14/20 supplementary iron, the validity distance of the total iron is 20x20 = 400. If you offset half of this value to one side of the iron and the other half to the other side of the iron by centering the additional iron, the area where the iron comes from will be revealed. Of course, the program would be the best...

Unfortunately, it's not like you said, Sta4cadte doesn't distribute additional reinforcements in half as you say. If we do it as you say, it will be a wrong application. Idecadin needs to come up with a solution to this, if there is a method that I don't know, I would love it if they share it with us.

Hello, the information given by Mr. Proisan is information on how additional equipment shows its place in the basic application plan. The representation of the locations of the additional reinforcements in the basic application plan can now be made using the 2D drawing possibilities. You can view the explanation in the link below.

You do not have permission to view link Log in or register now.